O'Connor v. . Webber

Cardozo, J. This is an action for personal injuries. The plaintiff was employed in the defendants’ butcher shop. When customers asked for chopped meat, it was one of his duties to chop it. The meat chopping machine is ran by electricity. At the top there is a hopper or funnel, four inches high, its diameter about four or five inches at the top and two and a half or three inches at the bottom. Beneath it is a revolving worm or screw, covered on all sides and open only at the top at its junction with the hopper. The meat is fed into the hopper and pushed down with a stick. The stick, touching the screw, flew out of the plaintiff’s hand; and with the shock, his hand slipped into the machine, and the revolving screw cut off the fingers. The charge of negligence is two-fold. It is said that there ought to have been a guard which would have made it impossible for the hand to reach the screw. It is said also that the stick, which was about six or eight inches long, ought to have been broader at the bottom, and that then the hand would not have slipped. We think that neither of the grounds assigned is adequate to support the verdict. This case does not involve a violation of section 81 of the Labor Law (Cons. Laws, ch. 31), which requires “ the owner or person in charge of a factory ” to provide proper guards for machinery. A butcher shop is not a factory (Labor Law, § 2; Shannahan v. Empire Eng. Corp., 204 N. Y. 543). The trial judge so ruled; and his ruling is not questioned. The statute not applying, the defendants’ duty is measured by the rule at common law. So measured, we think it is impossible to say that the duty *442 has been violated. The machine was of standard make and in common use. At the time of the accident no other or better machine had been designed. A witness for the plaintiff attempted to show that it would be possible to contrive a shield, but the contrivance, if possible, had never been published or adopted. There is no evidence that any similar accident had occurred before. There was no reason to believe that one would be likely to occur. The screw was not within reach of ready contact. It could be touched, but only by thrusting one’s -hand into it. Against casual contact by the thoughtless it was protected by the funnel. In such circumstances the defendants did their full duty when they furnished the only machine that was available in the market. They were not required to employ experts to design a new machine. They were not running a factory, where machinery is the principal thing’, the very life of the business. Those engaged in such callings are held under the statute to a duty more nearly absolute. The principal thing with the defendants was the retail sale of meat, and the chopper was a minor incident. If they were charged with a duty to become inventors of improved devices, and that too in an attempt to guard against remote and doubtful dangers, the same duty must attach to every one who uses a standard machine of any kind in his office or his home. The law does not impose' a duty so onerous (Carlson v. Phœnix Bridge Co., 132 N. Y. 273; Harley v. Buffalo C. M. Co., 142 N. Y. 31; Devlin v. Smith, 89 N. Y. 470, 476; Bauman v. Cowdin, 75 N. J. L. 193; Reynolds v. Merchants Woolen Co., 168 Mass. 501). What has been said answers also the suggestion that the plaintiff should have been furnished with a stick of some other shape. To charge the defendants with negligence on that ground is to go far beyond the rule which holds them to reasonable care (Harley v. Buffalo C. M. Co., supra.) *443 The judgment should be reversed, and a new trial granted, with costs to abide the event. Willard Bartlett, Ch. J., Hiscock, Collin, Cuddeback and Pound, JJ., concur; Hogan, J., not voting. Judgment reversed, etc.