Meade v. Parmentier Plywood Service, Inc.

Opinion by Mr. Justice Drew, Allen F. Meade, claimant, instituted this action of Scire Facias sur Mechanics Lien against Parmentier Plywood Service, Inc., defendant, to recover the contract price of a bituminous paved floor he constructed in an industrial building owned by defendant in the Township of Upper Moreland, Montgomery County. An affidavit of defense containing a set-off was filed wherein defendant averred that claimant had not performed his contract satisfactorily because the floor surface was not hard enough for its industrial purposes. A jury trial resulted in a verdict for claimant in the amount of $3,590.78, which sum represented the full contract price plus interest. Defendant’s motion for judgment n. o. v. having been refused, this appeal followed. As the only assigment of error is the refusal of the motion for judgment n. o. v., we are required to view the evidence in the light most favorable to claimant to determine if sufficient evidence was presented to justify the submission of the case to the jury. So viewed, the following are the pertinent facts. Claimant, a road-building contractor, agreed to construct a paved bituminous floor inside defendant’s new *394 building. For tbe reason he bad no experience with tbis type of floor, and before tbe terms of bis contract were agreed upon, be referred defendant’s agent, .Mr. Smith, to certain manufacturers of paving materials so that defendant could determine tbe type of material most suitable for its purposes. After ratber lengthy conferences with tbe engineers of tbe Colprovia Company, defendant decided to use .Colprovia products. Tbe contract specified that tbe floor was to consist Of certain stone “covered with one inch of Colprovia base material well rolled and finally covered with one-half inch of Colprovia top or wearing surface material which also shall be well rolled to an even bard surface.” After tbe floor was completed, defendant attempted to use tbe building in question for tbe storage of stacks of plywood. Tbe trucks or dollies upon which tbe plywood was piled bad metal wheels one and one-quarter inches wide and these narrow wheels sunk into tbe Colprovia surface of tbe floor to a depth of half an inch. Tbe workmen could not move these small-wheeled industrial vehicles on tbis floor. All efforts to harden tbe surface of tbe floor have failed, and there is no dispute as to the fact that the floor is not satisfactory for defendant’s purposes. Tbe interpretation of the contract pivots on the meaning of the words “even, hard surface”. Defendant does not contend that tbe floor was improperly laid or that it was not as bard as is normal for a Colprovia surface. Ratber, it is defendant’s contention that when claimant agreed to tbe provision for an “even, bard surface”, be agreed that tbe floor would be bard enough for use as an industrial floor in defendant’s warehouse. After tbe contract was entered into but before tbe floor was laid, claimant used Colprovia in the construction of a driveway which be was building on defendant’s premises. Defendant contends that when tbis Colprovia surfaced road did not get as bard as expected, claimant made an oral warranty that tbe inside floor would be *395 harder than the driveway and that its surface would carry certain weights. Claimant admits that he knew the general requirements of defendant, but denies that he made any warranty in regard to the floor. He said he could not do so because he had no experience in the construction of bituminous paved floors using Colprovia or any other black-top material. He further denies that he recommended Colprovia to defendant for the reason that he had no knowledge of the weight-bearing quality of this material. His testimony was that defendant selected the type of materials used after an independent investigation by its own agent, and that his sole duty was to lay the Colprovia material properly. Claimant maintains that the words “even, hard surface” mean as hard and even as a Colprovia surface normally attains when it is installed with proper care and skill. We agree with the following excerpt from the opinion of the learned court below: “Admittedly, Parmentier [defendant] did contact the engineers of the Colprovia Company and upon the advice of the engineers of the Colprovia Company decided to use their product. After making such decision, in reliance upon representations set by Colprovia, Parmentier entered into a contract with claimant to lay the floor, using Colprovia in accordance with the specifications set forth in the contract. Certainly there is no evidence of any agreement between Parmentier and Meade [claimant] for anything except a Colprovia blacktopping laid to certain specifications and to be rolled to a smooth hard surface. As to what was meant by ‘hard/ the trial judge left to the jury and there was ample evidence to justify a finding that the surface was as hard as could be produced by any method using Colprovia or perhaps any other blacktop material.” The conflicting testimony presented an issue of fact which was properly submitted to the jury. The evidence *396 was adequate to justify the finding of the jury that claimant complied with the terms of his contract and was entitled to be paid. The learned court below properly refused defendant’s motion for judgment n. o. v. Judgment affirmed.