Wittmer v. Fairhurst

Miller, J.: The learned trial judge dismissed the complaint on the authority of Dillon v. National Coal Tar Co. (181 N. Y. 215), but that case is distinguishable from this in several respects. The plaintiff in that case, a steamfitter of many years’ experience, was directed by the defendant’s foreman to take down a line of pipe which ran along the ceiling of the room above, and from fifteen inches to three feet away from the shaft, in which there was a keyway. He knew of the danger of working near a revolving shaft, and it was held that he assumed the risk although the danger was increased by the key way which he did not know of. Judge Werner prefaced his opinion in that case with the statement that, as the shaft was fourteen or fifteen feet above the floor and could be reached only by the use of a ladder, the defendant could not be charged with negligence under the Factory Act for failing to guard it, for which Glens Falls P. C. Co. v. Travelers’ Ins. Co. (162 N. Y. 399) was cited as authority; but in the latter case the Court of Appeals held that the necessity of guarding a set screw projecting from a collar at one end of a revolving shaft, which was approached only for the purpose of oiling the bearings and then by means of a ladder, presented a question of fact. Manifestly, the court did not intend in the Dillon case to overrule the case which it cited as authority for [307] the proposition announced. What was evidently intended by Judge Werner was that the failure to guard the shaft was not negligence as a matter of law, for that was what the case cited decided. Moreover, in'this case the plaintiff’s intestate was a mere helper and was engaged in the ordinary work of the factory. It does not appear how often the men were called upon to put patterns on these shelves or to take them down, but that that was customary and a part of their work was established by the fact that the shelves were there for that purpose. The master knew that in putting up or taking down the pattern the men might get near the shaft, and it was at least for the jury to say whether in the exercise of ordinary prudence he should not have anticipated that their clothing might get caught by the unguarded set screw. One witness testified to the position of the plaintiff when he was caught. The photograph in evidence makes it difficult to understand precisely how he could have got in the position described, but it is quite evident that the photograph does not plainly show the relative positions of the shelves, the shaft and the ceiling, at least as described by the witnesses. However, it does appear from the photograph that the shaft and the set screw were near and a little above the shelf on which the pattern was being placed, and it would appear that it was necessary to slide the pattern onto the shelf at the end near the set screw. It seems plain that, under those circumstances, it could not be said as a matter of law that the Labor Law (Laws of 1897, chap. 41o, § 81, as amd. by Laws of 1906, chap. 366), sometimes known as the Factory Act, did not require a shaft and set screw located as these were to be guarded. Hone of the cases cited by the respondents seems to be in point. In the case of King v. Reid (124 App. Div. 121) the unguarded fly wheel in which the plaintiff’s foot was caught had been in operation in the same condition for about twenty years without accident. It was so high above the floor as to preclude liability of a person’s foot being caught while walking by it, and the accident was one of those unexpected occurrences not reasonably to have been anticipated. The decision in Kirwan v. American Lithographic Co. (124 App. Div. 180) was put upon the ground that the shaft was guarded so as to protect the workmen in any position in which the master was bound to anticipate that they would be. In Horton v. Vulcan Iron [308] Works Co. (13 App. Div. 508) tlie plaintiff was not in the defendant’s employ. In Foster v. International Pager Co. (71 App. Div. 47) the plaintiff was at work on machinery which was being installed for use. What was said in Shaw v. Union Bag & Pager Co. (76 App. Div. 296) respecting section 81 of the Labor Law being intended solely for the protection of those actually operating the unguarded machinery is much weakened, if not indeed overruled, by later decisions of the same court. (Walker v. Newton Falls Pager Co., 99 App. Div. 47; 111 id. 19.) “What evidently was intended [i. e., by the statute] was that those parts of the machinery which were dangerous to tire servants whose duty required them to work in its immediate vicinity should be properly guarded, so as to minimize, as far as practicable, the dangers attending their labors.” (Glens Falls P. C. Co. v. Travelers' Ins. Co., sugra.) Here we have an unguarded set screw in a rapidly revolving shaft near where the plaintiff’s intestate, a mere helper, had to be to take down or put up patterns, which appears to have been part of his work. The case last above referred to has frequently been cited, but, so far as 1 can find, has never been questioned as a square authority for the proposition that the question of the master’s failure to discharge his duty was at least one of fact for the jury. The question of assumption of risk, the point upon which the Dillon case was really decided, could not upon the facts disclosed in this case be disposed of as a question of law, even independently of the Employers’ Liability Act. (Johansen v. Eastmans Co., 44 App. Div; 271; affd., 168 N. Y. 648.) But this action is brought under the Employers’ Liability Act, hence the question was for the jury. (Clark v. N. Y. C. & H. R. R. R. Co., 191 N. Y. 416.) The judgment and order should be reversed. LIirschberg, P. J., Jerks, Burr and Rich, JJ., concurred. Judgment and order reversed, and new trial granted, costs to abide the event.